You have no items in your shopping cart.
To be notified when this product is back in stock please click here.
Key points to note on these 683253-001 HP rail kits:-
This is a genuine HP 3PAR Rails 2U 24 For StoreServe 7000 Storage with Part #: 683253-001, 692981-001.
To Mount a 2U rail shelf to the rack:
Determine the location of the directional-specific rail matches with the side of a rack post.The following text is imprinted on both ends of the rails: FRONT-R and FRONT-L.
Align one end of the rail channel with the holes of the rack post, and then push to seat the locating pins in the rack.
Expand the rail to connect to the other end of rack post.
Secure the front and rear of the rail assembly to the rack post using four T25 Torx shoulder screws (Two in front, two in back) in the top and bottom holes. Tighten the shoulder screws with a torque of 19 in-lbs.
Figure 1: Mounting the 2U rail shelf
nstall the middle support bracket before transporting.
Align the middle support bracket holes with the top holes of the rails. The orientation of the middle support bracket is neutral.
Insert and tighten screws.
Figure 2: Installing the middle support bracket
Repeat steps 1 through 5 for the other rail.
Check both sides at the front and back of the rack to ensure all screws are installed properly.
Mounting a 4U rail shelf onto the rack
Verify each directional-specific rail matches with the side of a rack post.The following text is imprinted on both ends of the rails: FRONT-R and FRONT-L
Secure front and back of rail assembly to the rack-post by screwing in shoulder screws, part number, 5697-1199 (2X) on each end of the rack posts, front and rear. Torque to 19-in-lbs.
Install the middle support bracket before transporting:
:: Align the middle support bracket holes with the top holes of the rail(s). The orientation of the middle support bracket is neutral.
:: Insert and tighten screws.
Figure 3: Installing the middle support bracket
Snap one cage nut into the rack hole two positions above the rail on both sides.
Figure 4: Installing the cage nut
Use (2X) M5 x 6 mm screws provided in the kit to secure front of chassis.(One screw on each side of rack post). Torque to 13-in-lbs.
Simply enter your details below and we will send you an e-mail when “683253-001 HP 3PAR Rails 2U 24 For StoreServe 7000 Storage” is back in stock!
We will not send you any other e-mails or add you to our newsletter, you will only be e-mailed about this product!
Log In to be able to add this product to your Wish List.